![]() The longer over pass supports are screwed down to the door from below with long screws. My supports are made from 3/4' particle board scraps cut the same width as the track used, The thinner ones near the start and stop of the over passes are 1/8' solid cardboard and 1/4' cork. You will need to stand up the over passes now, and make your supports, to help hold the track together I used AFX track clips to keep the sections tight. I put the whole layout together and lined up the whole thing, getting rid of any gaps and making sure it was cantered on the base. I started by cleaning my track and polishing all the connections, this step will save some dead track section problems later. With the base covered in felt you can now lay the track.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |